33 10 205 Replacing pressure relief valve for rear axle differential clutch (Countryman models with AWD, except PHEV)
WARNING:
POISONING HAZARD IF OIL IS INGESTED/ABSORBED THROUGH THE SKIN
!
DANGER OF INJURY if oil comes into contact with eyes and skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
Preliminary work needed:
- Completely remove exhaust system.
- Remove heat shield at rear.
Removal:
Loosen pressure relief valve (1) and remove clutch (2) on the rear axle differential.
Installation:
Replace pressure relief valve (1).
Parts: Pressure relief valve
Coat seal of pressure relief valve with oil.
Screw in pressure relief valve (1) hand force and tighten.
Tightening torque 33 10 6AZ .
Required follow-up work:
- Installing the rear heat shield
- Completely install the exhaust system.
- Carry out the hang-on clutch "oil bleeding procedure".
Service function -> Drivetrain > Longitudinal torque distribution -> Bleeding
Waiting period of 60 seconds
Carry out the service function "bleeding procedure" again