Installing the seal for the panorama glass roof frame
NOTE:
TECHNICAL INFORMATION
The repair notes of bonded seals form the basis for these repair notes and must be observed without fail.
For additional information see: 54 10... REPAIR NOTES FOR BONDED SEALS
The repair notes of bonded seals form the basis for these repair notes and must be observed without fail.
For additional information see: 54 10... REPAIR NOTES FOR BONDED SEALS
- Clean bonding surface.
- Glue the seal (1)
on to the contact edge (A)
beginning without tension (compression) on the body aperture.
The upper edge of the seal must be flush with the roof outer skin.
- Glue the seal (1) on in sections.
- Create a sealing joint on the contact edge (A) .
Follow-up work
- Refer to INSTALL REAR GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to INSTALLING THE FRONT GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to CHECKING THE SETTING OF THE PANORAMA GLASS ROOF .
- Refer to ADJUSTING FRONT GLASS SLIDE/TILT SUNROOF PANEL .
- Refer to INITIALIZE PANORAMA GLASS ROOF .