Installing the model inscription on the door
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE
CAUTION:
Laser beam
.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Park the vehicle and the special tool 2 407 566 on a flat and even surface.
- Mount the laser on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Position the tool next to the vehicle.
- Align the horizontal laser beam on the lower edge of the door with dimension (A) = 14 cm.
- Align the vertical laser beam on the door edge with dimension (B) = 18 cm.
- Remove any adhesive residue and clean the bonding surface.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Pull off the liner (protective film) from the adhesive strips of the model inscription.
- Align the model inscription on the laser beams and press onto the door.