Install electric wastegate valve actuator

Repair kit for the electric wastegate valve controller 

Courtesy of BMW OF NORTH AMERICA, INC.

• Check the contact surface (1)  at the exhaust turbocharger for contamination and clean if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Slide the control rod (1) carefully  in the arrow direction up to the stop on the electrical wastegate valve controller (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Determine the dimension (A)  of the control rod (1)  of the electrical wastegate valve controller (2)  with a commercially available caliper gauge (3)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Supplement dimension (B)  on the control rod (1)  of the electrical wastegate valve controller with a commercially available caliper gauge (3)  to dimension (A)  .

  Dimension (B)  = 4.7 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nut (1)  .

  Parts:  Nut

• Insert and install the nut (1)  .
• Screw on nut (1)  to the stop.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (1)  .

  Parts:  Screws

  The screws (1)  are included in the repair kit.

• Hand-tighten the bolts (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (1)  .

  Parts:  Screws

  The screws (1)  are included in the repair kit.

• Tighten the screws (1)  from the repair kit hand-tight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten screws (1)  crosswise.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Electrical controller drive to exhaust turbocharger
  Replace screws.	Tighten screws crosswise. Tightening torque	3 ± 0.5Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Slide the lever (1)  of the wastegate valve carefully onto the control rod (2)  up to the stop.

  In the process, any effect of lateral force on the control rod (1)  is to be avoided.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Place the nut (1)  for the system on the lever (2)  of the wastegate valve.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nut (1)  .

  Parts:  Nut

• Place the nut (1)  for the system on the lever of the wastegate valve.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  The adjustment nuts must be locked using 2 open-end wrenches. If only one open-end wrench is used, there is a risk of the electrical controller drive being damaged.
• Counter support the nut (1)  with an open-end spanner (3)  .
• Tighten nut (2)  using open-end wrench (4)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Control rod for electric wastegate valve controller
  M6 Always use a second open-end wrench (for counter support) to tighten the lock nut!	Tightening torque	6 ± 0.3Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.

  The connector (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out and remove the standard tool (2)  from the exhaust turbocharger (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.