Removing heat shield at upper exhaust turbocharger
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
If installed: Removing the differential pressure sensor with the pressure line
- Unlock the detents (1) carefully.
- Guide out and remove the cover (2)
.
- Unlock plug connection (1) and disconnect.
- Disconnect the pressure hose (2) .
- Loosen screw (3) .
- Feed out differential pressure sensor (4)
and remove.
- Version A
Release the union nut (1) with special tool 5 A19 557 .
Feed the pressure hose (2) out of the holder (3) and remove.
- Version B
Release the union nut (1) with special tool 5 A19 557 .
Feed the pressure hose (2) out of the holder (3) and remove.
- Loosen screw (1).
- Feed out coolant line (2)
from the holder (3)
and place to one side.
- Loosen screw (1).
- Loosen screw (1).
- Feed out and remove the heat shield (2)
.
- Loosen screws (1) .
- Feed out heat shield (2)
on the exhaust turbocharger at the top and remove.