Install the heat shield on the exhaust turbocharger, top
- Fit and install the heat shield (1) on the exhaust turbo charger, top.
- Make sure that the heat shield (1)
is correctly positioned on the heat shield.(2)
.
- Tighten the screws (1)
on the heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to console/heat shield M6 Tightening torque 8Nm - Feed in and install the heat shield (2) .
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to console/heat shield M6 Tightening torque 8Nm - Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to console/heat shield M6 Tightening torque 8Nm - Fit and secure the coolant line (2) to the holder (3) .
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Coolant line to cylinder head M6 Tightening torque 8Nm If installed: Installing the differential pressure sensor with the pressure line
- Use the special tool 5 A19 557
for tightening the union nut.
- Version A
Feed in and install the pressure line (2) in the holder (3) .
Tighten the union nut (1) with the special tool 5 A19 557 .
TIGHTENING TORQUE SPECIFICATIONSPressure line on catalytic converter Coupling nut Tightening torque 20Nm - Version B
Feed in and install the pressure line (2) in the holder (3) .
Tighten the union nut (1) with the special tool 5 A19 557 .
TIGHTENING TORQUE SPECIFICATIONSPressure line on catalytic converter Coupling nut Tightening torque 20Nm - Guide in and install differential pressure sensor (4).
- Tighten down screw (3)
.TIGHTENING TORQUE SPECIFICATIONS
Differential pressure sensor to holder screw Tightening torque 4Nm - Replace pressure hose (2)
Parts: Pressure hose
- Connect pressure hose (2) to differential pressure sensor (4) .
- Connect connectors (1)
and lock.
The connector (1) must engage audibly.
- Guide in and install cover (2) .
- Lock the detents (1)
.
The detents (1) must engage audibly.