Removing the cylinder head cover
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
- Refer to REMOVING THE UPPER BULKHEAD COVER PANEL .
- Refer to REMOVING SUSPENSION CROSS-BRACE .
- Refer to REMOVING THE REAR BULKHEAD .
- Refer to REMOVING INTAKE PORT .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to IF INSTALLED: PARTIALLY REMOVING THE ENGINE VENTILATION LINE .
- Refer to REMOVING CLEAN AIR PIPE .
- Refer to REMOVING IGNITION COILS .
- Refer to REMOVING THE HIGH PRESSURE LINE BETWEEN THE RAIL AND THE HIGH PRESSURE PUMP .
- Refer to REMOVING HIGH PRESSURE PUMP .
- Refer to REMOVING INJECTORS .
- Refer to REMOVING BOTH ACTUATORS .
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
Bolts of the cylinder head cover
NOTE:
RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Unlock and loosen connector (1) .
- Loosen clamp (2) .
- Guide out wiring harness section (3)
for the engine and set aside.
- Loosen screw (1) .
- Guide out wiring harness section (2)
for the engine and set aside.
- Loosen screw (1) .
- Guide the coolant return line (2)
out of the holder (3)
and lay to one side.
- Evenly release all the screws in a sequence from (15) to (1) .
- Feed out and remove the cylinder head cover (A) .