51 47 490 Removing and installing/replacing underbody protection (front)

WARNING: This page is about a different variant/trim than selected.

NOTE: Picture for example purposes. There may be differences in detail in the case of other models.

Removal:

Loosen screws.

Pull forward underbody protection (1) below bumper cover (2) and remove.

Fig 1: Pulling Underbody Protection And Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in underbody protection (1) below bumper cover (2) and position at screw points.

Secure underbody protection (1) with bolts.

Tightening torque 51 71 5AZ .

Fig 2: Pulling Underbody Protection And Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.