Removing and installing/replacing airbag module for driver's knee protection (Cooper Convertible)
WARNING:
Read and comply with SAFETY INSTRUCTIONS for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
A damaged head airbag must be replaced.
A damaged head airbag exhibits an impaired protective function and in extreme cases loses its protective function altogether.
IMPORTANT:
Operations on pyrotechnical devices may only be carried out by authorized experts.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.
Removal:
Unscrew the screws (1).
Remove airbag module (2) downwards.
Unlock and disconnect the connector (1).
Remove airbag module.
Installation:
Connect the connector (1).
Position airbag module (2).
Tighten down screws (1).
NOTE:
Parts: replace screws (1).
Tightening torque 72 12 2AZ .
NOTE:
Make sure airbag module (1) is correctly fitted on guides (2).