Replace pulse sensor on exhaust camshaft (B48, B46) (Cooper S Convertible)

IMPORTANT: Read and comply with NOTES on protection against electrostatic discharge (ESD protection)!

Preliminary work needed:

Removal:

Unlock connector (1) and detach.

Remove screw (2).

Remove pulse generator (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check gasket, replace damaged gasket.

Part : Gasket

Install pulse sensor (3).

Tighten screw (2).

Tightening torque 13 62 1AZ .

Attach connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: