5111 Bumper, Front
TIGHTENING TORQUE SPECIFICATION (FRONT BUMPER)
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Bumper cover to front panel | F54/F55/F56/F57 | M6 | 6 Nm | |
| 2AZ Support, front top, to deformation element, front top | F54/F55/F56/F57/F60 | M8 | Nut M8x95 screw |
28 Nm |
| 3AZ Support, front bottom, to deformation element, front bottom | F54/F55/F56/F57/F60 | M6x30 | Screw | 8 Nm |
| 4AZ Vertical connection to deformation element | F54/F55/F56/F57/F60 | M6x20 | 11.8 Nm | |
| 5AZ Deformation element, bottom to adapter, front axle support | F54/F55/F56/F57/F60 | 11.8 Nm | ||
| 6AZ Deformation element, top, to engine carrier | F54/F55/F56/F57/F60 | Replace screw | ||
| Tightening torque | 100 Nm | |||
| Angle of rotation | 180° | |||
| 7AZ Adapter, front axle support to front axle support | F54/F55/F56/F57/F60 | 100 Nm | ||
| 8AZ Reinforcement strut at the support | F54/F55/F56/F57/F60 | 11.8 Nm | ||
| on cross connection | F60 | 25 Nm | ||
| 9AZ Air duct to deformation element top/bottom | F55/F56 | 4.6 Nm | ||
| F54/F57 | 8 Nm | |||
| F60 | 6 Nm | |||
| 10AZ Air duct to cross connection | F60 | 6 Nm |
TIGHTENING TORQUE SPECIFICATION
| Washer fluid reservoir holder to adapter plate of front axle support | ||
| Tightening torque | 10 Nm | |