Replacing rubber mount for transmission mounting (version 2)

Preliminary work needed: 

• Remove VEHICLE BATTERY .
• Secure ENGINE IN INSTALLATION POSITION .
• Remove LEFT FRONT WHEEL .
• Remove FRONT LEFT WHEEL ARCH COVER .

Removal: 

Unscrew the screws (1).

Release vehicle battery support (2) from holder and remove.

Release control unit (3) from holder.

Detach wiring harness (4) from battery tray (5).

Remove battery tray (5).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (2).

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) in wheel arch.

Remove transmission mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install transmission mount.

Tighten screw (1) in wheel arch.

Tightening torque 22 32 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Failure to comply with this instruction will result in serious damage to the transmission.

Tighten down screws (1).

Tightening torque 22 32 2AZ .

Tighten down screws (2).

Parts  : Replace screws (2).

Tightening torque 22 32 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Install battery tray (5).

Tighten down screws (1).

Install wiring harness (4) on battery tray (5).

Insert control unit (3) in holder.

Insert vehicle battery support (2) in holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install FRONT LEFT WHEEL ARCH COVER .
• Install LEFT FRONT WHEEL .
• Install VEHICLE BATTERY .