Installing and removing/replacing hydraulic valve for oil pressure control (B36 engine) (Cooper base)

Preliminary work needed: 

• Remove FULL-FLOW OIL FILTER .

Removal: 

Unlock and disconnect the connector (1)

Remove screw (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove hydraulic valve (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Parts  : Replace O-ring (1).

Oil O-ring (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install hydraulic valve (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (2).

Tightening torque: 11 00 2AZ .

Connect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install FULL-FLOW OIL FILTER .
• Check engine for leaks