Stripping Operations - Replacing Luggage Compartment Floor, Middle (Tail Panel Removed) (Cooper, Cooper S, John Cooper Works)

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list essentially represents the disassembly sequence.

Remove cross member trim panel via rear axle support

Release nuts and remove heat shield (1).

Release grommets (2).

Release the wiring harness at the attachment points (3) and tie it to the side.

Installation note:

Make sure the grommets are installed correctly. (watertightness).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove exhaust bracket.

Tightening torque 18 20 2AZ .

Courtesy of BMW OF NORTH AMERICA, INC.