REP-TAT-P-5218-02 Installing the seat frame
- Correctly position the rear seat backrest (5).
If necessary, feed in relative cables.
NOTE:
Perform the steps on the right and left side.
- Tighten the screws (4).
Tightening torques
TIGHTENING TORQUE SPECIFICATION
| Screw Replace screw. |
tightening torque 38 Nm |
- F56/57:
Correctly attach cable linkage (1) in holders (2) and (3).
Follow-up work
Install SEAT COVER WITH CUSHION
Install the THIGH SUPPORT on the front seat
Install the OUTER COVER on the front seat
Install the LEVER for seat height adjustment
Install the STEERING LEVER for backrest adjustment
Install the COVER for backrest adjustment
Install INNER COVER
Install FRONT SEAT