REP-TAT-P-5218-02 Installing the head restraint

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Correctly position the head restraint (2).
Press the locks (1) and install the head restraint (2) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Correctly position impact plate (1) on the support (3).
Clip in impact plate (1) in the marked areas (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screw (1).

Tightening torques

TIGHTENING TORQUE SPECIFICATION

Screw

Tightening torque 2.2 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work

Install the TRIM at the bottom of the aperture

Install the REAR PANEL from the front seat backrest

Install TRIM for backrest release