REP-TAT-P-5218-02 Install front seat

WARNING: Pyrotechnic components.
Danger! Immobilization period-threatening injuries!

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see: NOTES airbag safety regulations!

WARNING: Airbag unit.
Danger! Immobilization period-threatening injuries!

Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: NOTES airbag safety regulations!

Removing the front seat from the universal seat mount

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: RISK OF DAMAGE
Scratches.
Tools and sharp-edged components can cause scratches.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: RISK OF DAMAGE
Heavy component.
Heavy components can lead to injury or damage.

Remove and install heavy components with the aid of another person/other persons.

With the assistance of another, lift the front seat into the vehicle and position.
Place front seat to the rear and connect the connector (1).
Adjust the front seat to the rear.
Replace screws (1).
Parts: Screws
Tighten down screws (1).

Tightening torques

TIGHTENING TORQUE SPECIFICATION

M10
Replace screw.

tightening torque
42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torques

TIGHTENING TORQUE SPECIFICATION

M10
Replace screw.

tightening torque
42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnecting all battery ground leads

Further information is available.

Courtesy of BMW OF NORTH AMERICA, INC.