Removing and installing/replacing cover for instruments (Cooper Convertible)

Removal :

Press in the pin (1) from the clips (2) a maximum of 2.5 mm, up to the first detent.

Remove the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The cover (1) must only be slightly raised from the bottom, otherwise there is the danger that the fiber-optic conductor will break

Raise the cover (1) bottom from the detent (dimension X: maximum of 8 mm ).

Maintain the position of the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Press the cover (1) together on the positions (2 and 3) with both palms.

Tightly grip the cover (1) in this position and rotate it counter clockwise, until the detent releases.

Remove the cover (1) towards the rear.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation :

Engage the cover (1) and mount the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.