REP-TAT-P-6121-02-F5X Installing the battery
- Insert and install vehicle battery 4 .
- Insert the holder with the screw 3 and install.
- Tighten down screw 3
.
Tightening torques
TIGHTENING TORQUE SPECIFICATIONRetaining rail to battery carrier Hexagon screw Tightening torque 15 Nm - Connect the air bleeder hose (arrow) to the battery 2 .
- Insert and install the positive battery cable 1 .
- Tighten the nut on the positive battery cable 1
.
Tightening torques
TIGHTENING TORQUE SPECIFICATIONPositive battery terminal to battery Nut M6 Tightening torque 5 Nm - Install the tension strut 1 .
- Tighten screws (arrows).
Tightening torques
TIGHTENING TORQUE SPECIFICATIONTension strut to battery tray M8 Tightening torque 19 Nm - Install mounting for the seal 1
and fasten with the expanding rivet (arrow).
- Thread in and install battery earth lead 2 .
- Tighten nut 1
.
Tightening torques
TIGHTENING TORQUE SPECIFICATIONBattery terminal clamp on battery terminal M6 Tightening torque 5 Nm - Connect and lock the connector 3
.
The connector 3 must engage audibly.