REP-TAT-P-6761-01 Removing the convertible top drive unit
Prerequisite
- Rear left and right side trim panels SIDE TRIM PANEL removed.
Technical information
Adhere to the NOTES for opening the convertible top after emergency closing.
For additional information see: Opening/closing the convertible top in event of a technical fault.
Preliminary work
Remove SOFT TOP
Remove the convertible top drive unit
- Unfasten cable tie (1).
- Loosen screw (2).
- Swing the convertible top drive unit (3) down slightly and detach from the shaft (4).
- Loosen connector (5).
To avoid damage to the connector (5), if the convertible top drive unit (3) is faulty, the detent (6) can be cut off on both sides with a scalpel.