51 41 110 Remove and install/replace the driver's side handle recess (front passenger side)

Special tools required:

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Unclip the cover (1) with special tool 64 1 020 from the handle recess (2) and loosen the screw below it.

Tightening torque 51 41 3AZ .

Fig 1: Removing Cover With Special Tool (64 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip the handle recess (1) with special tool 64 1 020 starting at the rear.

Disconnect the associated plug connections and remove the handle recess (2).

Fig 2: Removing Handle Recess Using Special Tool 0 496 569 (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guides (1) and marked spring clips for handle recess (2) must not be damaged or missing.

Fig 3: Locating Handle Recess Marked Spring Clips And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: