51 14 002 Removing and installing/replacing front MINI badge

Special tools required:

00 9 322

IMPORTANT: The INSTRUCTIONS on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: The MINI badge is damaged when removed and must be replaced.

Removing badge:

Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .

Fig 1: Levering Out MINI Badge Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.

* Liner is the protective film on a new plate.

Fig 2: Identifying Adhesive Tape And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Special tools required:

00 9 322

IMPORTANT: The INSTRUCTIONS on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: The MINI badge is damaged during disassembly and must be replaced.

Removal:

Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .

Fig 1: Levering Out MINI Badge Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull off the Liner* from the adhesive tape (1) and place the MINI badge over the guide pines (2) on the Front compartment lid and press down firmly.

* Liner is the protective film on a new MINI badge.

Fig 2: Identifying Adhesive Tape And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.