37 14 511 Replacing front ride-height sensor

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Undo nut (1) from link at ride-height sensor.

Installation note:

Replace self-locking nut.

Tightening torque 37 14 4AZ .

Fig 1: Identifying Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Move sensor lever upward.

Undo screws (1), release plug connection (2) and disconnect.

Tightening torque 37 14 1AZ .

Fig 2: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: