37 14 511 Replacing front ride-height sensor
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Undo nut (1) from link at ride-height sensor.
Installation note:
Replace self-locking nut.
Tightening torque 37 14 4AZ .
Move sensor lever upward.
Undo screws (1), release plug connection (2) and disconnect.
Tightening torque 37 14 1AZ .
After installation:
- Check HEADLIGHT SETTING , correct if necessary