61 31 080 Removing and installing/replacing switch for hazard warning flashers

Necessary preliminary tasks:

Remove CENTRAL INSTRUMENT

Removal:

Unlock and disconnect the connector (1).

Release switch for hazard warning lights system (2) at metal clamps and press out of central instrument.

Fig 1: Hazard Warning Lights System Metal Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: Locking clamps on switch for hazard warning lights system (1) must not be or missing or damaged.
Make sure switch for hazard warning lights system (2) is correctly engaged.

Join switch for hazard warning lights system (2) in central instrument.

Connect connector (1) with switch for hazard warning lights system (2).

Fig 2: Hazard Warning Lights System Metal Clip

Courtesy of BMW OF NORTH AMERICA, INC.