61 62 100 Adjusting the washer jet for rear window washer system
NOTE:
Rear wiper must be in rest position.
Mark the contact point (1) with adhesive tape (A=55 mm/B=490 mm).
Operate the window washer system.
The spray jet must hit the mark.
If necessary, adjust the washer jet (3).
Attention!
Do not insert pointy objects into the washer jet (3) (risk of damage).
Open protective cap (2).
Use a suitable tool to adjust the washer jet (3) until the spray jet hits the mark.
If applicable, remove adhesive residue from the rear window.
Fill up with washer fluid.