41 33 731 Replacing girder of right cross connection

Read contents of BODY, GENERAL .

Necessary preliminary tasks:

Remove CROSS CONNECTION
Remove RIGHT HEADLIGHT .

Removal:

Release expanding rivets (1) and clip (2).

Undo screw (3) and place covers (4) with hood seal to one side.

Release deflection (5) from support for cross connection.

Fig 1: Expanding Rivets, Clip, Screw, Covers, And Deflection

G11648869

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Screws

G11648870

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the oil filler neck (1).

Release screw and nuts (2).

Fig 3: Oil Filler Neck, Screw And Nuts

G11648871

Courtesy of BMW OF NORTH AMERICA, INC.

Release 4 screws (1) and remove support (2) for cross connection.

NOTE: Shown without headlight fixture for clarity.

Fig 4: Cross Connection Support And Screws

G11648872

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Follow procedure for FRONT PANEL INSTALLATION .

Install support (2) for cross connection. Tighten all screws hand-tight.

4 Tighten screws (1). Tightening torque 41 33 5AZ .

Fig 5: Cross Connection Support And Screws

G11648872

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Shown without headlight fixture for clarity.

Tighten screw and nuts (1).

Tightening torque 41 33 3AZ .

Fig 6: Oil Filler Neck, Screw And Nuts

G11648871

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 41 33 4AZ .

Fig 7: Screws

G11648870

Courtesy of BMW OF NORTH AMERICA, INC.

Install covers (4) together with hood seal.

Tighten screw (3).

Fasten expanding rivets (1) and clip (2).

Mount deflection (5) on cross connection.

Fig 8: Expanding Rivets, Clip, Screw, Covers, And Deflection

G11648869

Courtesy of BMW OF NORTH AMERICA, INC.