51 11 050 Removing and installing/replacing support for front bumper

Necessary preliminary tasks:

Removal:

Release screws (1).

Release screw (2) and remove associated holder from below.

Loosen screws (3).

Release screw (4) from fanfare holder.

Feed out support (5) towards remove.

Fig 1: Front Bumper Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replacement:

Release screw (1) on left and right.

Remount holder (2).

Fig 2: Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Insert support (5).

Tighten down screws (1).

Tightening torque 51 11 8AZ .

Tighten down screws (2).

Tightening torque 51 11 2AZ .

Tighten down screws (3, 4).

Fig 3: Front Bumper Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.