66 51 030 Remove and install/replace KAFAS camera

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Expand two-part mirror base cover (1) by pressing from below and detach.

Feed out two-part mirror base cover (1) and remove.

NOTE: Latch mechanisms of two-part mirror base cover (1) must not be damaged.

Fig 1: Expanding Two-Part Mirror Base Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unclip cable in marked area.

Unlock retaining claps (2) and remove camera (3) in direction of arrow.

Fig 2: Removing KAFAS Camera

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guides (2) on camera (1) must be correctly inserted in counter supports on windscreen!

Make sure camera (1) is securely seated.

Fig 3: Locating KAFAS Camera Guides

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing windscreen:

Carry out the service function:

Driver assistance
Camera-based driver assistance systems
Calibration of camera-based driver support systems

NOTE: The calibration process of the KAFAS camera is not complete until the vehicle drives in traffic.
Tell the customer that some driver assistance systems are temporarily unavailable after vehicle pick-up.

NOTE: Heating of the KAFAS camera is integrated in the windscreen.
If the heating is defective, the windscreen must be replaced!