61 31 043 Removing and installing roof switch center

Special tools required:

00 9 325

Attention !

Follow SAFETY INSTRUCTIONS for handling light bulbs (interior lighting).

Attention !

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Removal:

Carefully unclip the trim (1) with the special tool 00 9 325 .

Remove the roof switch cluster (2).

Fig 1: Removing Trim

G11092895

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock latch mechanisms on both sides with screwdriver.

Remove roof switch cluster (1) from headlining (2).

Unlock and disconnect connector on rear side of roof switch cluster (1).

Fig 2: Roof Switch Cluster And Headlining

G11649833

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect connector on rear side of roof switch cluster (1).

Join roof switch cluster (1) in headlining (2).

NOTE: Ensure roof switch cluster (1) is correctly fitted and engaged.

Fig 3: Roof Switch Cluster And Headlining

G11649833

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Guides and retaining lugs (1) on cover (2) must not be damaged or missing.

Fig 4: Retaining Lugs And Cover

G11649835

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully join and clip in the trim (1) on the roof switch cluster (2).

NOTE: Ensure cover (1) is correctly fitted and engaged on roof switch cluster (2).

Fig 5: Installing Trim On Roof Switch Cluster

G11649836

Courtesy of BMW OF NORTH AMERICA, INC.

Attention !

Disconnecting the plug connection for the SOS emergency call button results in fault entries in the telephone control unit (restriction in the emergency call system).

After installation, read out fault memory and if necessary delete fault code entry.