62 30 530 Replace combination disc (Head-Up Display)

Special tools required:

IMPORTANT: Comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Risk of damage!

Do not scratch glass pane of head-up display.

Necessary preliminary work:

Remove TRIM FOR HEAD UP DISPLAY
Connect diagnosis system

Removal:

Fold out service flap (1) in direction of arrow.

NOTE: Undo the service flap (1) at the side using special tool 64 1 020 .

Fig 1: Folding Out Service Flap

G11649967

Courtesy of BMW OF NORTH AMERICA, INC.

Open the lock (1) in direction of arrow on both sides with special tool 00 9 030 .

Fig 2: Removing Lock On Both Sides Using Special Tool (00 9 030)

G11649968

Courtesy of BMW OF NORTH AMERICA, INC.

Bring the combination disc (1) into the service position (B) using the diagnosis system.

Fig 3: Installing Combination Disc Into Service Position Using Diagnosis System

G11649969

Courtesy of BMW OF NORTH AMERICA, INC.

Feed the combination disc (1) out of the Head Up Display (2) in direction of arrow.

Fig 4: Installing Combination Disc Out Of Head Up Display

G11649970

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed the combination disc (1) into the Head Up Display (2) in direction of arrow.

Fig 5: Installing Combination Disc Into Head Up Display

G11649971

Courtesy of BMW OF NORTH AMERICA, INC.

Run in the combination disc (1) in the Head Up Display using the diagnosis system.

Fig 6: Installing Combination Disc Into Service Position Using Diagnosis System

G11649969

Courtesy of BMW OF NORTH AMERICA, INC.

Close the lock (1) in direction of arrow on both sides with special tool 00 9 030 .

Fig 7: Removing Lock On Both Sides Using Special Tool 00 9 030

G11649973

Courtesy of BMW OF NORTH AMERICA, INC.

Close service cover (1) in direction of arrow.

NOTE: Make sure the service flap (1) is properly engaged.

Fig 8: Service Cover Location

G11649974

Courtesy of BMW OF NORTH AMERICA, INC.