LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2016 >> Cooper Base, 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Mini Technical Data - Cooper Base -- F55 & F56 >> Rear Brakes >> Rear Disc Brakes

Rear Disc Brakes

REAR BRAKES DISK BRAKES SPECIFICATION

IMPORTANT: New brake pads may only be installed if the brake disk thickness is greater than the minimum brake disc thickness.
Minimum brake disc thickness during general inspection (GI):
Nominal size thickness minus 2.4 mm
(Not applicable to perforated brake discs)
Perforated brake discs:
Nominal size thickness minus 1.6 mm
Depending on:
Engine type
Transmission version
Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.)
different brake discs can be fitted
The brake discs must always be identified by the relevant vehicle identification number and the BMW/MINI Parts Catalogue!
    
Thickness difference in the friction surfaces of the brake disc Max. mm 0.01
Nominal size (diameter x thickness) mm 259x10
Minimum brake disc thickness stamped on brake disc chamber mm 8.4
Pad wear warning from remaining brake pad thickness mm 3.7
scientia non olet · About LEMON Manuals