Rear Brakes
REAR BRAKES DISK BRAKES F57 SPECIFICATIONS
|
IMPORTANT:
New brake pads may only be installed if the brake disk thickness is greater than the minimum brake disc thickness.
Minimum brake disc thickness during general inspection (Gl): Nominal size thickness minus 2.4 mm (Not applicable to perforated brake discs) Perforated brake discs: Nominal size thickness minus 1.6 mm Depending on:
different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number |
||
| Thickness difference in the friction surfaces of the brake disc | Max. mm | 0.01 |
| Nominal size (diameter x thickness) | mm | 259x10 |
| Minimum brake disc thickness stamped on brake disc chamber | mm | 8.4 |
| Pad wear warning from remaining brake pad thickness | mm | 3.7 |
34.. Specifications for brake performance testing as part of regular periodic vehicle inspections as prescribed in 29 German road traffic licensing regulations German Car Safety Standards F57
BRAKE PERFORMANCE TESTING SPECIFICATIONS
| Model series | F57 |
| Base model | MINI ONE |
| Remarks | Convertible |
| Approved gross vehicle weight (kg) | 1670 kg |
| Maximum brake pedal force to achieve a deceleration rate of 58 % in (N) | 170 N |
| Minimum front axle brake force ratio in % | 57.5 % |
| Minimum proportion of rear axle braking force in % | 17.6% |
| Test area for brake pedal force (N) | 70-150 N |