LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2015 >> Cooper S, 2D Convertible, 1.6L Eng, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Body Equipment - Repair - Cooper (R50) , Cooper S (R53) & Convertible (R52)) >> Trim, Covers, Handle Trim >> 51 13 301 Removing and installing/replacing finisher - roof panel - side

51 13 301 Removing and installing/replacing finisher - roof panel - side

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Release door seal.

Remove screws (1).

Starting at rear, release finisher by pulling in direction arrows show.

Slide finisher forward to release front edge from clip.

Remove finisher.

Fig 1: Locating Retaining Screws For Finisher
G03306604Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque, refer to 51 13 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .

scientia non olet · About LEMON Manuals