51 47 000 Removing and installing/replacing front left or right entrance cover strip (inside)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL - COOPER (1.6L) R50/W10 .

Special Tools Required:

00 9 311

Remove bolt (1) securing seat belt slider bar.

Install Hint:

Tightening torque, (40 N.m.).

Release seat belt slider bar (2).

Remove front seat. Refer to 52 13 000 REMOVING AND INSTALLING DRIVER'S OR FRONT PASSENGER SEAT (NORMAL / MANUAL) .

Fig 1: Identifying Bolt Securing Seat Belt Slider Bar

G03306828

Courtesy of BMW OF NORTH AMERICA, INC.

Partially release door seal along entrance strip.

Partially release rear trim panel.

Ensure clip (1) is not damaged prior to installation.

Fig 2: View Of Door Seal Clip

G03306829

Courtesy of BMW OF NORTH AMERICA, INC.

Passenger side only:

Remove clip (1).

Passenger and driver side:

Using special tool 00 9 311 release entrance cover strip.

Replacement:

Passenger side only:

Remove fusebox cover panel.

Fig 3: Removing Clip On Passenger Side

G03306830

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Ensure any damaged clips (1) are replaced prior to installing.

Fig 4: View Of Clips Location

G03306831

Courtesy of BMW OF NORTH AMERICA, INC.