41 61 000 Hood Lid Removal And Installation
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove and install both gas-filled struts for engine hood.
The following illustration serves as a general guide and is to be applied to the relevant vehicle type.
Release screw (1).
Loosen screw (2).
Remove hood lid.
Installation:
Install engine hood at screw locations on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust engine hood. See 41 61 014 ADJUSTING HOOD LID .