11 65 Turbocharger and control
TIGHTENING TORQUE SPECIFICATION - TURBOCHARGER AND CONTROL
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Turbocharger to exhaust manifold | N14 | M8 nut - 10.9 | 20 Nm | |
| 2AZ | Stud to turbocharger | N14 | M8 x 125 | 15 Nm | |
| 3AZ | Bracket to turbocharger | N14 | M8 | 25 ± 6 Nm | |
| 4AZ | Oil feed to turbocharger | N14 | Banjo bolt M12 x 1.5 | 30 Nm | |
| 5AZ | Oil return to turbocharger | N14 | M6 x 100 | 8 Nm | |
| 6AZ | Bracket to crankcase | N14 | M8 x 125 | 19 Nm | |
| 7AZ | Front heat shield to rear heat shield | N14 | M6 x 100 | 4 Nm | |
| 8AZ | Coolant inlet and outlet lines to turbocharger | N14 | M14 x 1.5 banjo bolt | 35 Nm | |