34 11 Front Brake

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

FRONT BRAKE SPECIFICATION

IMPORTANT: New brake pads may only be fitted if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH). Minimum brake disc thickness during general inspection (GI):Nominal size thickness minus 2.4 mm(Not applicable to perforated brake discs)Perforated brake discs:Nominal size thickness minus 1.6 mmDepending on: Engine type Transmission version Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fittedThe brake discs must always be assigned by way of the relevant vehicle identification number and the BMW/MINI parts catalogue.
Different thicknesses on brake linings	Max. mm	0.01
Surface roughness of braking surfaces (precision-turned)	Ra μ	0.5... 3.5
Max. machining dimension per friction ring side (perforated brake discs must not be machined). Brake disc minimum thickness (MIN TH) must not be undershot.	mm	0.8
Nominal size (diameter x thickness)	mm	294x22
Brake disk minimum thickness (MIN TH) stamped on brake disk body	mm	20.4
Nominal size (diameter x thickness)	mm	307x24
Brake disk minimum thickness (MIN TH) stamped on brake disk body	mm	22.4
Wear warning from residual lining thickness	mm	3.7