52 26 000 Removing and installing/replacing left or right rear seat

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove LUGGAGE COMPARTMENT FLOOR TRIM PANEL

Release screws (1).

Installation note:

Tightening torque 52 26 10AZ .

Remove trim panel (2).

Fig 1: Identifying Trim Panel And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tilt backrest forwards.

Release screws (1).

Installation note:

Tightening torque 52 26 09AZ .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off cover (1) on left and right forwards.

Fig 3: Pulling Out Cover From Left And Right Side

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs (1) must not be damaged.

If necessary, replace faulty trim.

Fig 4: Identifying Trim Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation note:

Clean the screws and apply Loctite to screws.

Tightening torque 52 26 07AZ .

Fig 5: Identifying Rear Seat Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Cover entrance for protection purposes (risk of damage).
Lift out rear seat.