37 14 512 Replacing rear ride-height sensor

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Partially detach underbody panelling

Disconnect plug connection (1).

Release nut (2) and remove jointed rod from sensor lever (3).

Installation:

Replace self-locking nut.

Sensor lever (3) must point from ride-height sensor to lower control arm.

Fig 1: Identifying Plug Connection, Nut And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove ride-height sensor.

Installation:

Fig 2: Identifying Ride-Height Sensor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check HEADLIGHT ADJUSTMENT , correct if necessary