54 10 240 Removing and installing/replacing front glass slide/tilt sunroof cover
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 mins. (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release left and right screws (1).
Tightening torque 54 12 04AZ .
Carefully remove the glass slide/tilt sunroof cover upwards.
Installation note:
Replace Torx screw.
ADJUST glass slide/tilt sunroof cover.
Carry out INITIALIZATION .