23 00 039 Installing exchange gearbox (GS6-55BG)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, check gearbox oil level.
The vehicle must be parked on a level surface in the workshop to check the transmission oil level.
Use only the approved TRANSMISSION OIL .
The vehicle must be parked on a level surface in the workshop to check the transmission oil level.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug. Tightening torque: 23 00 1AZ
- Remove TRANSMISSION NOTE: No wheel alignment is required.
- If necessary, modify zero-gear sensor
- After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again
- The adjustment is performed using the "Service Function" of the BMW diagnosis system (learn/write the zero-gear sensor)
Reassemble the vehicle.
Check oil level.
The vehicle must be parked on a level surface in the workshop to check the transmission oil level.
Installation note:
Observe OIL/GREASE SPECIFICATIONS .