23 14 550 Removing/replacing zero-gear sensor

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again.
The adjustment is performed using the "Service Function" of the BMW diagnosis system (learn/write the zero-gear sensor).

Undo bolt (1) and place coolant expansion tank (2) to one side.

(do not drain off coolant)

Fig 1: Identifying Coolant Expansion Tank And Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

View from below.

Disconnect plug connection (1) on zero-gear sensor.

Fig 2: Identifying Zero Gear Sensor Plug Connection And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove zero gear sensor.

Tightening torque 23 14 2AZ .

Fig 3: Identifying Zero-Gear Sensor Screws

Courtesy of BMW OF NORTH AMERICA, INC.