13 62 618 Replacing the temperature sensor and charging pressure sensor (N14, N18)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Unlock connector (1) and remove.

Release screw and detach sensor (2) from charge air duct.

Installation note:

Check sealing ring for damage, replace if necessary.
When installing, coat sealing ring with suitable lubricant.
Tightening torque 13 62 6AZ .

Fig 1: Identifying Sensor, Screw, And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Check stored fault messages.

Clear diagnostic fault entries from fault memory.