13 62 560 Removing and installing or replacing the hot film air mass meter (N14, N18)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Gaiter with clamp fastening must be fitted dry and free from grease!
Sealing surfaces and connecting branches must be dry and free from grease.
If the gaiter with clamp fastening is not installed dry and free from grease, this may result in exhaust turbocharger failure!
Sealing surfaces and connecting branches must be dry and free from grease.
If the gaiter with clamp fastening is not installed dry and free from grease, this may result in exhaust turbocharger failure!
Necessary preliminary work:
- Read out fault memory of DME control unit.
- Switch off ignition.
Disconnect plug connection (1).
Release clamp (2).
Release screws (3).
Tightening torque 13 62 1AZ .
Pull the gaiter off the hot film air mass meter.
Installation note:
Fit gaiter dry and without grease.
The connecting branch on the hot film air mass meter must be dry and free from grease.
Remove hot film air mass meter (4) in direction of arrow.
NOTE:
Check stored fault messages.
Delete fault memory.
Delete fault memory.