13 74 001 Removing and installing or replacing the sound generator (N14, N18)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Air duct with clamp fastening must be fitted dry and free from grease!
Sealing surfaces and connecting branches must be dry and free from grease.
If air ducts with clamp fastenings are not installed dry and free from grease, this may result in exhaust turbocharger failure!
Sealing surfaces and connecting branches must be dry and free from grease.
If air ducts with clamp fastenings are not installed dry and free from grease, this may result in exhaust turbocharger failure!
Necessary preliminary work:
- Remove INTAKE SILENCER HOUSING .
Unfasten hose clamps.
Tightening torque 13 71 5AZ .
Release screw (1).
Detach sound generator (2) from air duct and remove.
Installation note:
Fit air duct dry and without grease.
Connecting branch on the sound generator must be dry and free from grease.