34 52 525 Replacing one front pulse sensor

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove WHEEL

Remove cable from holder (1) on spring strut.

Release screw (2) and remove pulse generator (3).

Installation:

Tightening torque 34 51 4AZ .

Fig 1: Identifying Holder, Screw And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Installation:

Make sure plug connection engages correctly.

Fig 2: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean bore hole for pulse sensor and grease with Staburags NBU 12/K lubricating grease.

IMPORTANT: Check sensor head prior to installation for damage, replacing if necessary.

Fig 3: Locating Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.