34 00 050 Bleeding brake system with DSC

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Read and comply with GENERAL INFORMATION .

When replacing or repairing, observe the filling and bleeding instructions for the following parts:

Tandem brake master cylinder
Hydraulic unit
Components and connecting lines which are fitted between these assemblies.

Connect bleeder unit with max. 2 bar filling pressure.

A second person is needed to help carry out this work.

Always use BMW/MINI-approved brake fluids, refer to OPERATING FLUIDS .

Connect Diagnosis and Information System.

Open cover (1).

Connect bleeder unit to expansion tank (2) and switch on.

Connect DIS.

Select path: Service functions - Chassis/Suspension - Traction control systems - Bleeding procedure.

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.

Charging pressure should not exceed 2 bar.

Fig 1: Identifying Expansion Tank And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Fully rinse the brake system

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Follow same procedure on rear left, front right and front left wheel brake.

Fig 2: Locating Bleeder Valve On Rear Right Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

Bleeding rear axle brake circuit

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Close vent valve.

Run bleeding routine with DIS with bleeder valve open.

After completing routine, press brake pedal 5 times to floor; clear and bubble-free brake fluid must flow out.

Close vent valve.

Repeat procedure at rear left.

Fig 3: Locating Bleeder Valve On Rear Right Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

Bleeding front axle brake circuit

Connect bleeder hose with collecting tray to bleeder valve on front right brake caliper.

Close vent valve.

Run bleeding routine with DIS with bleeder valve open.

After completing routine, press brake pedal 5 times to floor, clear and bubble-free brake fluid must flow out.

Close vent valve.

Repeat procedure at front left.

Fig 4: Connecting Bleeder Hose With Collecting Tray To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off bleeder unit and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to max. level.

Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.

Fig 5: Checking Brake Fluid Level

Courtesy of BMW OF NORTH AMERICA, INC.