62 10 100 Removing and installing/replacing steering column rev counter
Attention.
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE
Release screws (1).
Carefully pull rev counter (2) in direction of arrow.
Raise trim panel (3) in direction of arrow and unlock the connector housing behind it.
Unlock plug connection (4) and disconnect.
Installation note:
Make sure rev counter wiring harness is correctly laid.
Replacement:
Attention.
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE
Release screws (1).
Carefully pull rev counter (2) in direction of arrow.
Raise trim panel (3) in direction of arrow and unlock the connector housing behind it.
Unlock plug connection (4) and disconnect.
Installation note:
Make sure rev counter wiring harness is correctly laid.
Replacement: