13 90 500 Replace the tank vent valve (N16)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Read out fault memory of DME control unit.
Switch off ignition.

Installation location:

Tank vent valve is fitted at bottom on intake plenum.

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Unlock and disconnect lines (1 and 2).

Unlock connector (3) and remove.

Detach tank vent valve (4) from holder and remove.

Fig 1: Removing Tank Vent Valve From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Read out fault memory of DME control unit.
Delete fault memory.